Skip to content

Man overboard from stinger

What happened?

A member of the crew fell overboard through an opening in the stinger. The incident occurred with the vessel alongside in port. A team of three electricians were conducting function checks on a new roller box camera on the stinger. One of the team fell about 2 metres into the water through an opening in the stinger floor grating. The person remained conscious and was able to swim to a lifebuoy that had been pre-deployed as part of the task. He was recovered via the quayside ladder and was given first aid treatment for minor scratches on his neck and ear.

Stinger as seen from the quay

Opening through which person

A view of the rescue of the person who fell

What were the causes? What went wrong?

  • A requirement to move the vessel prevented the work on the stinger being completed on the quayside, which would have removed the fall potential;
  • Two weeks before the incident, a management inspection of the stinger had identified damage to handrails and walkway grating including the section from which the fall occurred. Repair was considered low priority because this area was not one that was normally accessed, and remedial work was neither planned nor immediately actioned;
  • The controls identified in the risk assessment were not verified by the supervising persons at the site;
  • The Permit to Work (PTW) was authorised without review or confirmation of control measures;
  • “Task seen as routine”- there was no task-specific Toolbox Talk (TBT) conducted; a ‘pre-shift’ briefing was considered adequate. The persons involved saw the task as “routine and simple”;
  • The work team involved in the incident observed unsafe conditions, including openings in walkways and missing handrails, but did not stop the job to re-assess, or apply any Management of Change procedure.

What actions were taken?

  • Adequate planning and risk assessment before starting work;
  • Appropriate review of work area before start to ensure the specified controls provide safe working conditions;
  • Stop work authority should be re-emphasised as an obligation and responsibility for all;
  • Specific risk of falling overboard should be considered not only for work over the side but also for work near the side.

Members may wish to refer to:

Safety Event

Published: 23 June 2020
Download: IMCA SF 19/20

Relevant life-saving rules:
IMCA Safety Flashes
Submit a Report

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of all. The effectiveness of the IMCA Safety Flash system depends on Members sharing information and so avoiding repeat incidents. Please consider adding safetyreports@imca-int.com to your internal distribution list for safety alerts or manually submitting information on incidents you consider may be relevant. All information is anonymised or sanitised, as appropriate.

IMCA’s store terms and conditions (https://www.imca-int.com/legal-notices/terms/) apply to all downloads from IMCA’s website, including this document.

IMCA makes every effort to ensure the accuracy and reliability of the data contained in the documents it publishes, but IMCA shall not be liable for any guidance and/or recommendation and/or statement herein contained. The information contained in this document does not fulfil or replace any individual’s or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.