Skip to content

Near miss: Potential dropped object due to unsecured door

What happened?

Step Change in Safety reports an incident in which there was a potential dropped object due to an unsecured door on a load. The incident occurred when a flat pack spooler unit was being lifted from a vessel onto a platform.

What went wrong? What were the causes?

During the lift, the storage door had opened which revealed a small toolbox inside which was not secured.

Actions taken?

Secondary retention solution put in place:

Recommended size of the tie wrap is between 4.7mm and 13.2mm for drop locks. Secondary retention must be in place on all units with drop locks for both outward and inward transportation

Unsuitable secondary retention methods include linchpins, R-clips, spring/roll/nappy pins or any other type of pin device. All these means of secondary retention for lifting equipment or securing at height can spring open or be knocked out.

See here for the Step Change safety moment.

Members may wish to refer to the following incident:

Safety Event

Published: 23 January 2018
Download: IMCA SF 02/18

Relevant life-saving rules:
IMCA Safety Flashes
Submit a Report

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of all. The effectiveness of the IMCA Safety Flash system depends on Members sharing information and so avoiding repeat incidents. Please consider adding safetyreports@imca-int.com to your internal distribution list for safety alerts or manually submitting information on incidents you consider may be relevant. All information is anonymised or sanitised, as appropriate.

IMCA’s store terms and conditions (https://www.imca-int.com/legal-notices/terms/) apply to all downloads from IMCA’s website, including this document.

IMCA makes every effort to ensure the accuracy and reliability of the data contained in the documents it publishes, but IMCA shall not be liable for any guidance and/or recommendation and/or statement herein contained. The information contained in this document does not fulfil or replace any individual’s or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.