BSEE: worker injured in fall from height into water
The Bureau of Safety and Environmental Enforcement (BSEE) has published Safety Alert 343 in which a worker fell 24m into the water.
What Happened?
The worker was replacing a control valve on the platform crane. A 3m ladder was placed between the overboard handrail and the crane. As the mechanic was positioned on the crane skid (located around 2m above deck) he realised that he would need to descend the ladder to retrieve tools for the job. After repositioning himself on the ladder, his grip or footing was lost, causing him to fall backwards and land in the water approximately 24m below.
He was transported back to the platform by a fishing vessel, 45 minutes after the incident, where he was then flown ashore for treatment; he was later diagnosed with fractures of cervical and lumbar vertebrae.
What went wrong?
- High winds prevented the worker from retrieving a life vest which was thrown to him, but was later able to retrieve a vest which had been placed into a life ring;
- Strong currents caused him to drift further from the platform;
- The worker did not follow the safe work practices which required him to use fall protection for heights exceeding 6ft above the deck;
- The United States Coast Guard (USCG) regulation (33 CFR 146.20) requiring the use of work vests when working near or over water was also not followed;
- The job safety analysis (JSA) did not identify falling as a potential hazard during this operation.
The BSEE recommended that operators:
- Ensure that proper procedures are implemented establishing minimum requirements for working at height;
- Make sure personnel working at heights have knowledge and experience required to perform the job safely;
- Review all pre-job planning procedures to ensure all necessary response procedures are included:
- consider equipment position and hazards when completing pre-job planning so as to minimize risk.
Members may wish to refer to the following:
- Fatality: Fall from height arising from a failure to use personal protective equipment
- Near-miss: improper use of fall-arrest equipment leads to fall
- Working at height [Be prepared to work safely promotional video]
Safety Event
Published: 13 February 2019
Download: IMCA SF 02/19
IMCA Safety Flashes
Submit a Report
IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of all. The effectiveness of the IMCA Safety Flash system depends on Members sharing information and so avoiding repeat incidents. Please consider adding safetyreports@imca-int.com to your internal distribution list for safety alerts or manually submitting information on incidents you consider may be relevant. All information is anonymised or sanitised, as appropriate.
IMCA’s store terms and conditions (https://www.imca-int.com/legal-notices/terms/) apply to all downloads from IMCA’s website, including this document.
IMCA makes every effort to ensure the accuracy and reliability of the data contained in the documents it publishes, but IMCA shall not be liable for any guidance and/or recommendation and/or statement herein contained. The information contained in this document does not fulfil or replace any individual’s or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.